Trains.com

GRR School of Hard Knocks

1285 views
9 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    December 2007
  • From: Monterey Peninsula, Calif.
  • 160 posts
GRR School of Hard Knocks
Posted by Independent Operator on Friday, May 15, 2009 7:36 AM

Some of the things that I have learned the hard way since 2005:

Before buying big engines make sure they will negotiate your curves.  Thats the reason I added the side yard railroad with 8 foot diameter curves.

Do a lot of research before building and buying.

Don't work on the layouts when you have had a few too many.

Before building a tunnel make sure your highest engine and cars will go through it.

Don't walk away from a running train that has Bachmann knuckle couplers. 

Don't expand the railroad into the wife's garden without prior negotiations.

Be careful of who you buy from on Ebay.

Keep up on maintenance and repair of your equipment.

Accept the fact that the knuckle couplers on MTH engines like to mate with Aristocraft couplers a lot more than Bachmann couplers.

Don't run the trains during high wind conditions.

Don't soak the cleaning pads on your Trackman 2000 track cleaning car with metal polish.

Don't go into a bidding frenzy on Ebay  when you have had a few too many.

 

 

RUDY JAGER, CEO OF THE LONE WOLF RAILROAD 

TRUST ME--I USED TO WORK FOR THE GOVERNMENT!

  • Member since
    September 2003
  • 262 posts
Posted by pimanjc on Friday, May 15, 2009 5:19 PM

For health and longivity, item #7 is the most important.  Don't ask me how I know.

JimC.

"Never promise more than you can give. Always give more than you promise." ~JC "You don't stop laughing because you grow old, You grow old because you stop laughing." ~AU
  • Member since
    July 2006
  • From: Shire Counties UK
  • 712 posts
Posted by two tone on Saturday, May 16, 2009 6:06 AM

Hi Rudy      Good points most inportant is not to drive track though the parners flower garden  I let mine do the garden design she is very good at it and I dig the flower beds and plant for her them she will tend them all summer

                Age is only a state of mind, keep the mind active and enjoy life

  • Member since
    December 2007
  • From: Monterey Peninsula, Calif.
  • 160 posts
Posted by Independent Operator on Saturday, May 16, 2009 11:16 AM

A couple of items that I forgot to add are:

Don't let the wife near the layout when she has the waterhose in her hand with the nozzle set on high pressure Sad  Allways do the watering yourself.

Don't leave a train running when you wander off and leave two chihuahua dogs in the vicinity at the same time.

 

 

 

 

RUDY JAGER, CEO OF THE LONE WOLF RAILROAD 

TRUST ME--I USED TO WORK FOR THE GOVERNMENT!

  • Member since
    February 2004
  • From: North, San Diego Co., CA
  • 3,092 posts
Posted by ttrigg on Saturday, May 16, 2009 5:05 PM

OK Guys: The idea is to get her involved with the GRR. Once she has taken some level of pride of ownership, easements into unexplored areas of the garden are easier to obtain. In my case certain long-term expansions have been "directed" to traverse selected flowerbeds and tree beds. When she says things like "I want to be able to send the train away and not have it come back for a while", I respond with "well, if it went down the rose bed it could." She says, "why haven't you started doing it yet?"

Yep! She's a keeper!

Tom Trigg

  • Member since
    February 2004
  • From: North, San Diego Co., CA
  • 3,092 posts
Posted by ttrigg on Saturday, May 16, 2009 5:12 PM

Independent Operator
Don't leave a train running when you wander off and leave two chihuahua dogs in the vicinity at the same time.

Make sure the Pappillons (4 1/2 pounds of fur and bark) are not asleep in the tunnel! 

Tom Trigg

  • Member since
    February 2002
  • 9 posts
Posted by wernerjp on Saturday, June 27, 2009 6:35 PM

Don't rush in and use 6 ft long flex track for a Garden railroad with a lot of curves.   Spent much time figuring out how to solder the joints together (I am too cheap to buy the rail clamps) - used a plywood table on saw horse to solder three pieces together at once and then carried them to the roadbed and bent them to fit with the assistance of my supportive wife.  Since they are more "flexible" than sectional track spend much time keeping these flexible track sections level on the roadbed and at some locations in gauge.   I used the 1 inch (or 3/4 inch)  plastic conduit pipe roadbed design with stakes to hold this pipe in place.  You then screw the track to this pipe (reference a great series in Garden Railways on how to build a railroad).

Next time I will use the flexible track for mostly straight runs and use sectional for the curves unless I mount the track on a exterior grade plywood rather than on the plastic conduit pipe.

  • Member since
    June 2008
  • From: N. California & Nevada
  • 448 posts
Posted by g. gage on Monday, June 29, 2009 5:11 PM

Never start on a garden (railway) project without showing the project to the Vice President. After a couple of hours at the emergency room and seven stitches to her knee, I was removing rocks for a stone wall that had spilled onto a garden pathway.

 

D#@!, Rob

 

  • Member since
    June 2006
  • From: Oakley Ca
  • 1,407 posts
Posted by dwbeckett on Monday, June 29, 2009 6:00 PM

I must agree with what you had to about a FEW TOO MANY  after running a 9 car + 3 F3 passenger train,  the engins separated from the rest of the train. It TICKED ME OFF, so I shut down  my power pack after the engins crossed over the second bridge ( closest spot near me ) to check the coupler. Then I returned to my second too many. realy could have been bad move to turn the power pack back on I was in the mood to see bad train wreck........... 

The head is gray, hands don't work , back is weak, legs give out, eyes are gone, money go's and my wife still love's Me.

  • Member since
    December 2006
  • From: Michigan City, In.
  • 781 posts
Posted by spikejones52002 on Monday, June 29, 2009 8:43 PM

 I will never understand why they (manufactures) will not get together and have a standard knuckle coupler.....  They all put out the same hook and loop.

Search the Community

FREE EMAIL NEWSLETTER

Get the Garden Railways newsletter delivered to your inbox twice a month

By signing up you may also receive occasional reader surveys and special offers from Garden Railways magazine. Please view our privacy policy