Where can you buy a 3/64" Allen wrench?

[MikeSanta]

I have several MPC engines which have the adjustable set screw you need a 3/64" Allen wrench to turn to adjust or remove to oil the armiture. I got one years ago at an Ace Hardware but they no longer carry them. Nor does anywhere else I tried including Micro-Mark. If the one I have breaks or I lose it I'm out of luck. Does anyone know someone who sells small tools like that? Thanks for your help

[ADCX Rob]

How many do you need?  CLICK HERE.

However, don't take that screw out to lube the armature... just lift the entire brushplate off and place a tiny dab of Lucas Red 'N' Tacky #2 on the top of the shaft for a lifetime lube. The screw rarely needs any wear adjustment after the factory sets it.

[MikeSanta]

Thank you very much, ADCX Rob!  I ordered the 10 pack so I can leave one in each engine I have. I have something like the Lucas stuff: I got the brand that Jim Barrett recommended and I use that instead of the Lionel stuff. It seems to work better.

[ADCX Rob]

MikeSanta

...ordered the 10 pack so I can leave one in each engine I have...

I have 60-70 of this type of motor built starting in 1970, and not a single one has ever needed to have that screw turned. Don't do it unless you are fixing something that somebody else messed up and moved that screw.